Filament is Voxelab Burnt Titanium ASA The filament had previously been dried and used about 8 months ago. It had sat in a box, in a sealed bag, with dessicant, that when opened STILL had somewhat of a vacuum seal (I make an attempt to partially vacuum seal the bags that I store filament in prior to placing them back into their box for storage). I live in an area that averages about 55-60% relative humidity. I pulled the filament out recently, and used it in the new Qidi Plus 4 that I received recently, and wanted to run a temperature tower. I was surprised by the results. The bad tower is fresh out of 8 months of storage. The good tower is after 10hours @ 70C in a filament dryer. Before drying (fresh out of the stored bag): After drying at 70C for 10 hours: The purge filament from the transition from pre-dried to post-dried Can clearly see when the dried filament starts to come through the nozzle submitted by /u/Look_0ver_There |
Leave a Comment